Another Turntable Offering: Thorens “VN-150” w/ Bolivian Rosewood Plinth, Rega RB-250, Extras.
Why spend more to buy a refurbished Thorens turntable from Vinyl Nirvana?
Buying vintage electronic equipment on eBay can be a gamble. To better your chances at winning, you want two things: 1) Plenty of information about the auction item; and 2) A seller you can trust. When an Thorens turntable is refurbished by Vinyl Nirvana, it undergoes a multi-step inspection and tuning regimen. Ask another seller of a Thorens table on Ebay these questions and see if you can get a response…
Is the motor running silently? Any unhealthy bearing noise?
Is the spindle straight? Was the spindle cleaned of old belt residue, which can cause rumble?
Does the belt properly interface with the spindle on both 33 and 45 rpm?
Is the belt new or in near mint condition?
Is the proper length belt installed? (Differences of less than an inch can result in speed changes.)
Is the proper width belt installed? (Differences can result in belt slippage or faulty change of speed.)
Has the platter bearing been inspected? Is it straight, true, and without significant wear?
Has the platter bearing well been inspected? Was it cleaned of old grease and contaminants? Was it properly lubed with appropriate oil?
Is the tonearm functioning properly? Any significant side-to-side motion, which can adversely affect tracking? Is range of motion appropriate? Is anti-skate functioning? Is appropriate tonearm weight installed?
Is cueing adjusted properly?
Were electrical connections cleaned and inspected? Headshell leads? Tonearm recepticle? RCA plugs? (Dirty connections can contribute to hum problems.) Are all connections tight? ( I use Dexoit products, highly recommended.)
Is transport screw intact? Is it functioning properly?
Are dust cover hinges intact and not stripped?
Was all wiring beneath the turntable inspected? Were worn solder joints re-soldered?
What is the condition of the AC cord? The interconnect cable?
Are springs in good working condition? Have worn springs been replaced? Has spring suspension been tuned? (This is an art learned through having set up dozens of these tables.)
Was the speed checked by strobodisc at 33 and 45 rpm?
Was headshell inspected? Is there any stripping? Do the cartridge screws hold tight? Are the leads brittle?
Is the tonearm rest original? Is it functioning properly?
Is a proper mat installed?
Is the base intact? Are the rubber feet intact?
If a Thorens table fails to pass any of the above inspections, Vinyl Nirvana corrects the problem before it gets listed. If the turntable is unsellable due to too many defects, it becomes a parts unit to be used in the restoration of other Thorens units. In addition to this multi-step inspection, each turntable is thoroughly detailed with appropriate cleaners. The average cleaning takes up to two hours. Though the tables Vinyl Nirvana sells will vary cosmetically, they will always be clean. Can you trust Vinyl Nirvana as a seller? Please read our ebay feedback (username vinylnirvana3345)regarding sales of turntables. See our testimonial page.
This Week’s Custom Thorens, The New VN-150!
Okay, you can tell from my website and my descriptions that I get pretty excited about turntables and the peripheries…even after all these years. Well, multiply that excitement tenfold and you will know how I feel about this specific turntable. I have been modifying the wonderful and venerable Thorens TD – 150 for over 10 years. For about five years I have been fantasizing about creating the turntable you see before you. The basic idea was to extend the footprint of the turntable to allow a Linn/TD-125 sized arm board. From there, well things just took off. The gorgeous plinth is made from Bolivian Rosewood, an exotic hardwood with amazing grain patterns. The armboard is also fashioned from the same wood. To round out the unit, and make this first one extra special, I installed a re-wired and upgraded Rega RB-250.
Cosmetically, this turntable is essentially new. The Bolivian rosewood plinth and armboard are brand new with not a single blemish to report. The metal portion of the plinth is also new. I had custom plates made from brushed aluminum; they look amazing! The new custom set-on style dust cover is included. You can choose from smoked acrylic (pictured) or clear. Finally, the Bren record weight is also included.
The custom plinth and armboard were crafted by a woodworker with over thirty years of experience. It was finished in mulitiple coats of Tung oil.
The Upgraded Rega RB-250
If you have never compared a stock Rega RB – 250 to one that has been rewired with upgrade wiring, it is a night and day difference… a cliche I rarely use, but in this case it’s true. In this case, my arm tech ended the wiring in a high-quality junction box that allows you to use your own RCA cables. In addition, as part of the rewiring, the arm ground was removed from the signal path. Finally, the plastic counterweight and stub were upgraded with the RB – 300 stainless steel stub/weight. (An upgrade that is universally hailed.)
Overall, this is a stunning table with a serious arm capable of handling cartridges in the $500 to $2000 range with ease. I would be happy to mount any cartridge for the new owner for $30. If I install the cartridge, it makes set-up incredibly easy for set-up.
This table will be packed like it is a fragile pane of glass. I simply care too much for these tables to just shove them in a box. I will carefully pack the table in extra sturdy boxes. and bubble wrap. I prefer Fedex Ground. Lastly, I am truly not in this for the money. What I love best is introducing someone new to the joys of vinyl, getting someone back into vinyl who left it for the “superiority” of cds, or helping someone else who does appreciate it to “move up.” In that regard, I do what few sellers do…if the buyer needs it, I can supply up to one hour of help by phone with set up. (At a mutually arranged time.) In general, most buyers don’t need it, but if there IS a problem, I am there.
Your table is guaranteed to look and work as described, or you may return it within ten days of arrival for a full refund, minus return shipping charges. After ten days, all returns are for merchandise credit only.
Some comments from buyers….
“Outstanding & dedicated craftsman. Helpful hints. Personal attention.”
“The best! A great communicator who goes above and beyond in the service dept.”
“If you want an excellent reconditioned vintage turntable, Dave’s the Man! Thanks”
“When eBay was invented, nobody dreamed there’d be a seller as great as Dave!!”
Email me if you are interested in purchasing this turntable or another one I have slated for restoration.